Titanium Wedding Rings & Sets ?
Each ring is custom machined in 6/4Ti. Sizes from 3 to 15, widths 2mm to 6mm.
Polished, etched or smooth, concave inside. BEAUTIFUL and weigh less than 1g.
call 770-424-6863 to order..
$175.00ea. or $325.00 matched set.
In the relatively unlikely event that you injure the finger that a Ti ring
is on, and swelling occurs necessitating the cutting off of the ring, Ti
rings are next to impossible to cut, and the likelihood of losing the
finger is much higher than with a gold or silver ring.
Again, this is a low likelihood event, but should be considered
nonetheless.
To explain what Diane is saying, one of the newsgroup (Gary Helfrich?)
who is a volunteer fireman tried cutting a Ti ring with one of their
tools and it cut it, no problem.
Yes again. Want to place bets on the NEXT time this discussion
comes around?
Myself I can't wait for someone to start wanting Aermet 100 wedding
bands... now THAT will be hard to cut. But I've cut Titanium handlebars
with a regular hacksaw so the wedding bands don't pose much trouble,
Hmmm, Think I'll dry my dremel cutting disc on a broken Ti saddle
rail and see how quick it slices thru.
That's fine for a fire department, but I think the point they were
making was for the typical hospital emergency room or even the typical
field surgery issue of say, injuring yourself while many miles from
the nearest fire truck.
I rarely pay attention to the Ti ring discussions so I missed what
Tool Gary said he used (he did list a tool didn't he?) but myself I'd
just use a hacksaw or dremel cutting tool.